Samsung J4 Plus Dead By Water For 10 Minutes !!! By MST

Hello, my friends today we got Samsung j4 plus dropped in water for about 10 minutes. Flash LED light is blinking, remove sim card first I'm going to open the device from back, so I can first unplug the battery. We need the device to be out of power for a while, until I open it. You can heat using your heat gun at 250c for every 30 seconds. Okay, ,. There is huge amount of water inside I putted plastic piece between battery and battery connector lets remove screen protector.

The LCD is broken very deadly, so I don't need to damage it more than that I'm going to open it with caution. , I don't want to damage the screen if its still working so I'm going to take my time to remove it in a very slow. You can heat your LCD at 250c. You need to be caution in the bottom of the device. The screen flex cable is very near to the edges.

So 1 mm is enough to go, throw remember in the bottom of the device near the back and home button. You need to be caution. , you don't need to cut that fell cable. If you are beginner with this, you must take more time. This device took me 3 working hours,, from start to finish, so you maybe need more than that.

You can use multiple tools, It should make it easy for you. I have started from the bottom, because LCD is broken from top. If I have started from there, I'm pretty sure it will be defected. So this is would be the thing to protect it. I'm almost finished.

I should have been done long time ago. , this broken thing delays my work as you can see it's so difficult to handle this broken glass. You need to clean every piece from this device. , this device was in water for about 10 minutes. I got a problem with this board.

It was too big to get this board into ultrasonic cleanser, remove IC shields, don't touch any IC on the board or move it, Otherwise, you would damage the board.

Source : MST