Google Pixel 3XL Rear | Front Camera Replacement By Geardo

Hi everyone welcome back to Guido. Today we will show you how to replace the cameras on the Google Pixel 3 XL mobile phones. To start, we need to have the right tools to proceed with the repair which you can find in the description. The first step is the vacuum: removal to remove the back cover. It needs to heat gently around three acreages until the pasted adhesive becomes soft, carefully work around on the edges, and once you feel the heating is enough, use a suction cup to lift the back cover in between insert plastic CarPlay tool and gently cut the adhesive around. While you are taking out the back cover, be gentle.

The touch ID sensor is attached to the back cover to unplug the touch I'd move, the rear car to the left hand, side and disconnect the flex cable by pulling the tape and the connector next undo, four screws and remove the bracket on the right hand, side and then disconnect seven connector plugs on it. Next peel the tape and undo two screws to remove the small bracket then undo the plug next undo. Five screws to take out the logic board bracket on top next move to the top and release three screws to remove the bracket. Next disconnect the plug near the rear, camera and unplug both front cameras by using a pry tool. A quick note: it is not required to take off the logic board to replace the front cameras.

So if you have a broken front, camera replace the required front, camera and reassemble the phone next to take out the logic board, undo, two more screws and the plug gradual, lift the board, while moving the other flex cables, be gentle and lift the board and then rotate the board and disconnect the rear camera, replace the back camera and start the reassembly process. First place the logic board in the body, be gentle and slowly move other flex cables by placing it next insert two screws and secure the logic board and then connect some flex cables to the logic board, make sure the connections are secured and then plug two front. Cameras into the logic board now place the bracket by adding three screws on the top. Next. Add the shield by adding two screws.

Next place the logic board bracket by locking in five screws next add the long bracket by inserting four screws. Finally, we can add the main vector with the touch ID sensor, connect the touch ID and ensure the connection is secured before installing the main backup make sure it has enough glue on it. If not use, b7000 glue or new double-sided backlog. Adhesive hope you have enjoyed the repair guide. Let us know if you have any questions, please like share and comment on.

Our videos do not forget to hit the subscribe button. Thank you.

Source : Geardo