Google Pixel 3XL Charging Port Replacement By Geardo

Hi everyone welcome back to yellow. Today we will show you how to replace the charging port flex on the Google Pixel 3 XL mobile phones. To start. We need to have the right tools to proceed with the repair which you can find in the description. The first step is the back cover removal to remove the back cover. You need to heat gently around the back cabbages until the pasta, adhesive becomes soft.

For this we are using a heat gun, carefully work around on the edges, and once you feel the heating is enough, use a suction cup to lift the back cover in between insert a plastic car prior tool and gently cut the adhesive around. While you are taking off the back cover, be gentle. The touch ID sensor is attached to the back cover to unplug the touch I'd move, the rear car to the left hand, side and disconnect the flex cable by putting the tape and the connector next undo, four screws and remove the bracket on the right hand, side and then disconnect seven connector plugs on the right hand, side of the logic board. Next, peel, the tape and undo two screws to remove the small bracket and then undo the plug next under five screws to take out the logic board bracket on top next move to the top and release three screws to remove the bracket. Next disconnect the plug near the rear camera and then unplug both front cameras by using a pry tool.

Next to take out the logic board, undo, two more screws and the plug now gradually lift the board while moving other flex cables, be gentle and lift the board and then turn the board and, if needed, disconnect the rear camera next on the bottom, take out the protector cover by undoing five screws next disconnect to antenna to release the logic board from the board, take out the logic board and next undo, three screws and gently pull out the broken charging port flex. Cable. Next, replace the new charging port flex, cable and secure it by adding three screws. Next connect, both antenna, heads and place the cover by adding five screws. Next connect the back camera and place logic board in the body, while moving other connector plugs.

Be gentle in this process next insert two screws and secure the logic board and then connect eight flex, cables to the logic board, make sure the connections are secured and then plug two front cameras into the logic board. Next connect the plug above the rear, camera and place the bracket by adding three screws on the top. Next add the shield by adding two screws next place, the logic board bracket by adding five screws next verify the battery connection and then add the long bracket by inserting four screws. Finally, add the main back cover with the touch ID sensor, connect the touch ID sensor and ensure the connection is secured before installing the back cover make sure it has enough glue on it. If not use b7000 glue on your double-sided back cover, adhesive hope you have enjoyed the charging port replacement guide and let us know if you have any questions, please like share and comment on.

Our videos hit the subscribe button for more videos.

Source : Geardo