iPhone XR camera replacement By How-FixIT

Hello everyone, today I show you how to disassemble iPhone XR and replace camera module Unscrew two screws near the lightning port. Using a hairdryer, heat the display surface for 1-2 minutes. In this way, the glue heat between the iPhone case and the display, so it will be easier to open the case. Apply the suction cup to the bottom edge of the display and pull up on the ring. Next, push the plastic mediator between the display and iPhone case. If you cannot do this with a plastic mediator, take any thin plastic card and insert it between the case and the display, then it will be easier to pry with a mediator.

Now, evenly and slowly, open the display around the perimeter of iPhone. The iPhone case opens like a book; the display opens to the right side. Using a Tri-Wing screwdriver, unscrew the 3 screws and remove the metal panel. Now you can disconnect the battery cable from the mainboard. Next, unscrew the 2 screws and remove the second metal panel.

Unscrew another 3 screws with a Tri-Wing screwdriver and two screws with a PH00 screwdriver. Disconnect 3 cables of the display from the mainboard. For replace the camera on the iPhone XR, you need to unscrew the 2 screws on the metal panel, the first screw is unscrewed with a PH00 screwdriver, the second can be unscrewed with a flat screwdriver. Disconnect the camera cable from the mainboard, then gently pry the camera and remove it from the iPhone case. In the description of this video, I left a link where you can buy a new camera for iPhone XR.

Place the camera in the case and gently push it down. Connect the camera cable to the mainboard. Install the metal panel on the camera module and fasten 2 screws. For test the iPhone, connect 3 display cables to the mainboard and only after that connect the battery cable. Turn over the display and turn ON the iPhone.

Check how the phone works and, if everything is in fine, let’s go to the gluing of the case. Remove the old adhesive tape from the iPhone case. After, using medicine alcohol wipe the surface of iPhone case and display module. Take a new adhesive tape and apply on the case. With this tape, you keep the iPhone waterproof.

I left a link where you can buy this adhesive tape in the description. Connect 3 display cables to the mainboard and only after that connect the battery cable. Next, install all panels and fasten screws. Now turn over the display and press the display to the case. Fasten 2 screws near the lightning port.

Installing a sim card and now you can turn on the iPhone. Good luck.

Source : How-FixIT