BlackBerry keyone back removal and installation By CELL PRO

It's so Bruce Milligan, here from cell pro repair solutions. What I'm doing today is I noticed there wasn't any YouTube videos on how to properly put this back on the BlackBerry key. One and I found a pretty solid way of doing that, or a perfect way of doing that. Many ways. It was difficult, so I'm dreading taking this off so, but here we go, so I'm, basically taking it off the same way, I'm going to be putting it back on I'm going to slide it off from that way. Alright! So here's the back here as you can see it's the BlackBerry key one I've just replaced the screen due to the issues that we have with the screen falling off.

What we're going to be doing is we're going to be taking this little divot here or this little outcrop on the plastic, and you're going to be taking it here, and you just want to kind of slide it in there now, when doing so, the camera sort of slides into place quite nicely as well so yeah, so that's kind of where we are, and you want to try and get this part in there as well. You kind of want to lever it in almost so kind of want to get that side in you want to sort of lever it like that in a certain way, but it does take a little of coaxing to do that and take a little of pressure on there. There you go. You want to press that camera lens down a little and then just as just it's out there, you can see this little notch here. It's out, you want to press that down and just slide it into place like that.

Now, at the same point, on the back of this there's a little X, you want to make sure it's lining up. It's about here and then at that point, once it's lined up, it should go in nicely. So again you want to kind of lift pry from back here or just a dash and work your way into it like that and there it's on so and then obviously around the edges, click it into place. This must have turned on slightly in the process. Yes, you would just work that puppy into place like so all right.

Thank you very much.

Source : CELL PRO