HTC U Ultra Teardown and Reassemble - Fixez.com By Fixez.com
HTC? U ultra tear down and reassemble warning you're performing this repair at your own risk. We claim no responsibility for any damages that might occur to perform this DIY repair. You will need a nylon, spider, SIM card, ejection tool, fine tip curved tweezers precision, knife set premium: two millimeter red adhesive, roll multipurpose heat gun, t5, Torn, screwdriver, Phillips, screwdriver, playing cards power down your HTC. U, ultra phablet eject the SIM card and micros card tray, the HTC? U ultra rear panel is glued on solidly and is a tight fit within the narrow bezel apply heat to soften adhesive, use a playing card to attack the adhesive and dislodge the rear panel from the phone remove the following: 16 t5 torn screws remove the top plastic shield that covers the motherboard, lift the bottom plastic shield out of the phablet, remove the following: 2 Phillips screws: sponge: the HTC: u ultra battery connector up from the board, detach the HTC? U ultra loudspeaker and pry it out of the phone detach the bevy of cables from the HTC? U ultra motherboard, remove the following: 2 Phillips screws, carefully, pry the motherboard up and out of the HTC phone extricate the 12-megapixel HIT you ultra rear-facing camera from the motherboard, remove the impressive 16 megapixel HTC? U, ultra front-facing selfie camera pop off the small board. That includes a proximity sensor and a microphone remove the metal bracket, disconnect the ribbon cables from the daughter board, pry the HTC? U ultra daughter board up from the mid-frame. It includes the USB connector on microphone spring contacts and some control hardware.
The vibrator and 2 signal cables are also still connected to the board. The HTC battery is well wedged and adhered in place use a sponger to help free it from the adhesive securing it to the mid-frame, lift out the 3.8 5 volt 3000 William per hour; HTC. U ultra battery tweet the HTC? U ultra earpiece speaker out of the chassis, remove the following: 10 Phillips screws extract the HTC you ultra metal frame Pl zen, remove the fragile power and volume buttons ribbon; cable, the HD 5.7 inch HTC. U ultra display assembly is glued on solidly to the frame apply heat. This is off.
Need me to use a precision knife to create enough space to insert a playing card, use a playing card to slicer the sticky adhesive, take your time and apply additional heat as needed once you slice through the adhesive, be mindful of the dual display cables when decoupling the HTC? U ultra screen from the frame, all the replacement parts and repair tools used in the video are available at WWF. It's easy calm! Don't forget to subscribe to our YouTube channel like us on Facebook and follow us on Twitter, make sure to take a look at our other DIY smartphone and tablet repair tutorials.
Source : Fixez.com
Phones In This Article
Related Articles
Comments are disabled
Latest Articles
